Product Description

This series of products uses polyester resin and epoxy resin as the main base material to make thermosetting powder coating.

Product Features

Good adhesion, excellent mechanical properties such as impact resistance;Good leveling and gloss;Strong chemical resistance and corrosion resistance;Better heat resistance and light resistance stability than pure epoxy powder.

Special effects

Various wrinkles, metal, pearlescent effects and mixed colors, etc.

Application areas

Suitable for coating of various indoor products, widely used in any indoor purposes such as furniture, household appliances, industrial equipment, sports equipment, toys, hardware machinery, store shelves, lamps, etc.

Transportation packaging

Carton packaging, lined with two layers of polyvinyl chloride plastic bags, net weight of each box is 20kg. Non-hazardous items can be transported in various ways, but should be kept away from direct sunlight, moisture and heat, and contact with chemicals.

Hygiene and safety

Operators should wear dust masks during use to avoid inhaling dust and minimize long-term contact between skin and powder coating. Paint attached to the skin can be washed with soap.

Powder properties

Specific gravity	1.4~1.8g/cm3 (depending on the formulation and color)
Particle size	Depending on the purpose, the standard type has an average particle size of 35~40 microns, less than 10 microns powder <10%, greater than 100 microns powder <0.5%.
Volatile matter	<1%
Softening point	60~95℃ varies depending on the color gloss
Storage stability	Epoxy/polyester powder coatings should be stored in a dry, ventilated room below 35℃, and avoid direct sunlight. If stored in an air-conditioned room, the powder must be stored at room temperature or the same (temperature) as the spraying equipment before use to avoid moisture. Under this condition, the powder can be stored stably for 12 months. If it exceeds the period, it must be re-tested. If the result meets the requirements, it can still be used. Note: For low-temperature curing types and powders with a gloss of less than 40% (60°), the storage temperature should be below 30℃.

Coating properties

Test items	Inspection standard or method	Inspection index
Appearance	Visual inspection	Various board surface effects
Impact	GB/T 1732	≥50Kg·cm
Bending	GB/T 6742	≤2mm
Cupping	GB/T 9753	≥8mm
Hardness	GB/T 6739	≥H~2H
Adhesion	GB/T 9286	Level 0
Salt spray resistant	GB/T 1771	500h; Scribed area: unidirectional rust ≤2.0mm; Unscribed area: no abnormality
Moisture and heat resistance	GB/T 1740	500h No abnormality
Photoaging	Poor light resistance, not recommended for outdoor use
The above coating performance indicators may decrease slightly as the gloss decreases.
Spraying	This series of products are suitable for the following spraying methods: corona electrostatic spraying; friction electrostatic spraying; electrostatic fluidized bed spraying; fluidized bed hot dip coating.
	Coating thickness: Use between 40~150 microns, recommended film thickness is 50~80 microns. Average coverage: 10~12 square meters/kg, film thickness 60 microns (calculated based on 100% usage rate)
Curing conditions	200℃/10 minutes is recommended, and it can also be designed according to user needs: 140℃/30 minutes, 160℃/20分钟，180℃/10 minutes, etc.